Steps to Follow:
To make this poster by hand:
- Start with a piece of ArtSkills neon pink poster board and lay it out horizontally.
- Add blue holographic blocks borders to the top and bottom of your poster. To make these, cut the blocks design shown in the poster picture above out of blue holographic poster board using an ArtSkills Poster Knife. Be sure to exercise caution when cutting.
- Add the emphasis of your title, "LIBBY," to the center of your poster using yellow ArtSkills Jumbo Neon Poster Letters on top of blue ArtSkills Jumbo Classic poster letters. Move the yellow letters to the right a bit to create a drop shadow effect and remember to substitute "LIBBY" with your name.
- Centered above your name, add "VOTE" using blue ArtSkills Quick Stick Foam Letters.
- Centered below your name, add "FOR HOMECOMING QUEEN" using black ArtSkills Quick Stick Foam Letters.
- Add blue holographic directional arrow ArtSkills Eye Catchers pointing to each corner of your name. Then, add a silver holographic burst Eye Catcher on both the left and right of "VOTE."
- Using the poker provided in your Poster Lights kit, poke holes through your name from the back of your poster to put ArtSkills Poster Lights. Space them evenly to fit all the lights in your set.
- Once all your holes are poked, push your lights through them. Add batteries to your battery pack, then adhere it to the back of your poster using the adhesive square provided. If your light wiring is taking up too much room, glue it all to the back of your poster using hot glue. Be careful if you choose to do this.
- Your poster is now complete. Go get your name out there!
|